Description

This is custom BCM programming for owners switching from an Automatic Transmission to a Manual for 100% OEM Operation.

This is a ship in service for your BCM that sets it up for manual transmission operation. The BCM is easily accessible behind the drivers side lower IP trim, this module is plug and play except for the setup instructions below.

PLEASE NOTE:

Custom BCM programming REQUIRES a Brake Pedal Position and SDM key relearn. This procedure takes less than two minutes with a Tech 2 (or other compatible high end scan tool). The car CAN be driven after installation however the Airbags may not deploy and it may be hard to get the vehicle into gear or the stop lamps may turn on incorrectly until these procedures are completed.